Productcatalog
Accessories
Adapters and Weld-Solder Connectors For easy and simple installation of ESK products and other components in the system, a range of adapters and connectors are available from ESK. Special Adapters For the connection of test- and equalization lines to the compressor housing ESK manufactures ...
Discharge Line Mufflers (GD)
General By using reciprocating or screw compressors pressure pulsations will be introduced into the discharge line. These pulsations may cause annoying noise and vibration throughout the connected pipe work. To reduce these pressure pulsations it is recommended to fit a muffler into the discharge ...
Filter Driers (FT)
General Filter driers are important components to set up refrigeration systems, because moisture has to be extracted, acid should be bind and particles has to be filtered out. The solid cores are easy replaceable via a precision –flange with a guided mounting spring. ESK –Filter driers can be ...
Intelligent Level Control (ILC)
General With our partner, the firm WURM-Systeme, an electronic module has been developed as an intelligent level control and monitoring unit in various versions. The handling was significantly improved. We present the different installation options into ESK components and give suggestions for ...
Liquid Receivers (S)
General The liquid receiver acts as a stock of liquid refrigerant for the evaporators. However, the receiver should be sized to hold the full system charge during service work. Selection The receiver should be sized according to the amount of refrigerant in the plant. The maximum admissible ...
Oil Level Regulators (OR)
General In multiple-compressor parallel systems, oil level regulators are installed to maintain an adequate oil level. Oil is fed conventionally from an oil reservoir. The correct selection of all components are necessary to guarantee the function of regulators. Oil level regulators are ...
Oil Reservoirs and Combinations (OSA)
General In the oil reservoir, any refrigerant trapped within the oil is boiled-off and the oil is cooled and kept available. ESK oil reservoirs are normally equipped with two sight glasses, with float ball level indicators, for upper and lower level indication, and with two shut off ...
Oil Separators (OS)
General Depending on the operating conditions, a lack of lubricant in the compressor crankcase will occur with the following consequences: Too low an oil pressure Bearing damage Cylinder/piston damage Motor damage This carry-over of oil into evaporator will adversity affect heat ...
Oil Separators BOS2
High Performance Oil Separator BOS2 The following illustration shows that the portion of oil particles at < 1 µm in discharge gas flow rises with increasing discharge gas temperature. These aerosol particles collide less with the 3-layered stainless steel strainer elements of standard ...
